PHOTON Electronic Mandalay


<% products.product_name %>

<% price|number %> MMK   <% old_price|number %> MMK
Item code : <% item_code %>
In stock : <% stock|number %>
<% attribute_name1 %>
<% attribute_name2 %>
<% attribute_name1 %>


 Save for later



The TCS3200 is a color sensor which has an array of photodiodes. To detect color, the photodiodes are arranged in groups of four with red, green, or blue filters on three of the photodiodes and no filter on the fourth. This allows the sensor to measure the amount of red, green, blue, and white light that hits the sensor.

This module incorporates four white LEDs to illuminate an object of which you wish to measure the color of. The white light from these LEDs hits your test object and reflects back to the module's sensor, which then measures the amount of red, green, blue, and white light that was reflected.

As is, this module is susceptible to ambient light. We recommend creating a shroud to keep ambient light out of the test area or use the sensor in a dark area with little ambient light to get better results.

This module does fit on a standard breadboard, but it spans the width of the standard prototyping pins, requiring connecting wires to be connected to the breadboard under the module.


SPECIFICATION

· Chip: TCS230

· Input voltage: DC 3 ~ 5V

· Output frequency voltage: 0 ~ 5V

· Distance: 10mm PCB

· Size: 31.6 (mm) x24.4 (mm)

PIN SPECIFICATION

Header one on the left side of the board:

· S0: Output frequency scaling selection input (along with S1)

· S1: Output frequency scaling selection input (along with S0)

· OE: Output Enable – if held low, the output of the module is turned on

· GND: Ground – connect to 0V

Header two on the right side of the board:

· S3: Photodiode type (along with S2)

· S2: Photodiode type (along with S3)

· OUT: Output – A square wave appears here showing the intensity of the detected colour

· VCC: Power – connect to 2.7V-5.5V


Average Rating(<% products.rating %>)

User Rating   

<% products.rating %> average based on <% products.rate_user %> reviews.


Write A Review
5 stars
<% products.rate5 %>
4 stars
<% products.rate4 %>
3 stars
<% products.rate3 %>
2 stars
<% products.rate2 %>
1 star
<% products.rate1 %>